Ase g1 engine questions Study guides, Class notes & Summaries

how many employed in automotive field ? - correct answer 14 million define specialized tech - correct answer expert in one area of auto repair what does ASE stand for? - correct answer Automotive Service Excellence how many ASE test to become a master tech? - correct answer 8 vehicle identification is determined by? - correct answer frame and chassis new test in 2013 added with...

ASE G1 Exam Questions and Answers 100% Pass | Guaranteed Success Coolant should be tested for - a. Proper color b. Freezing point (temperature) c. Specific gravity *d. Both b and c Two technicians are discussing a compression test. Technician A says that the engine should be cranked over with the pressure gauge installed for "4 puffs." Technician B says that the maximum difference between the highest-reading cylinder and the lowest-reading cylinder should be 20%. Which technician i...

ASE G1 Test Questions and Correct Solutions 2024 Technician A says that oil should be squirted into all of the cylinders before taking a compression test. Technician B says that if the compression greatly increases when some oil is squirted into the cylinders, it indicates defective or worn piston rings. Which technician is correct? - Answer -B only During a cylinder leakage (leak-down) test, air is noticed coming out of the oil fill opening. Technician A says that the oil filter may be cl...

ASE G1 Engine Questions.

ASE G1 MLR Exam Questions and Answers 100% Solved | Already Passed The automotive repair process is a 6 step process. What is the last step? - Verify the Repair A vehicle comes in the shop with an engine noise. What should be done first? - Discuss the noise with the customer A spark ignition engine has a flapping sound near the front. Which of the following could be the cause? - Loose timing belt A tight timing belt makes what type of noise? - Whining Sound An orange colored liquid is f...

ASE G1 Questions and Answers A tight timing belt makes what type of noise? - Answer ️️ -Whining A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on the odometer. The MOST likely cause for the leakage is: - Answer ️️ -Plugged Transmission Breather filter Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before clamping the boot? - Answer ️️ -Burping Steering dampers can be used to r...

Automotive service Final Exam Questions and Answers Already Passed How many tests must be passed to become an ASE Master Automobile Technician? 8 What tests must be passed to obtain the ASE Undercar Specialist Certification? Suspension Steering, Brakes, Exhaust Where are the 2 ASE test centers in the Twin Cities Metro area located? Bloomington and woodbury The advanced L1 ASE test measures a technicians knowledge of what vehicle areas? emissions failures and driveability Union automotive tec...

ASE G1 Test Questions and Correct Solutions 2024 Technician A says that oil should be squirted into all of the cylinders before taking a compression test. Technician B says that if the compression greatly increases when some oil is squirted into the cylinders, it indicates defective or worn piston rings. Which technician is correct? - Answer -B only During a cylinder leakage (leak-down) test, air is noticed coming out of the oil fill opening. Technician A says that the oil filter may be cl...

ASE G1 Questions and Answers 100% Pass Technician A says that when pressure testing a radiator cap, a special adapter is needed. Technician B says the best way to check thermostat operation is while it is in the engine. Who is right? Tech A A technician is checking resistance in an engine's spark plug wires using an ohmmeter. A general rule is to replace a wire if resistance is over: 30,000 ohms Technician A says that in an ignition system, the voltage supplied to the coil during starting is...

ASE G1 Questions and Answers 100% Pass Technician A says that when pressure testing a radiator cap, a special adapter is needed. Technician B says the best way to check thermostat operation is while it is in the engine. Who is right? - Answer ️️ -Tech A A technician is checking resistance in an engine's spark plug wires using an ohmmeter. A general rule is to replace a wire if resistance is over: - Answer ️️ -30,000 ohms Technician A says that in an ignition system, the voltage su...