ASE B6 Test - Damage Analysis & Estimating Questions and Answers 2023 ASE A6 Test Prep (Electrical & Electronic Systems) Exam Solved 100% ASE A6 Electrical/Electronic Systems Exam with Complete Solutions ASE BRAKES Exam #1 Latest Updated ASE A8 Practice Test Questions and Answers 100% Correct ASE-A...
[Show more]
What is the difference between a unitized frame and a uni-body? - ANSWER-There is no difference. In a uni-body or unitized vehicle, the frame and body are incorporated into a single welded structure. Should exhaust damaged systems be welded and repaired, or replaced all together? - ANSWER-Replace...
Preview 2 out of 11 pages
Add to cartWhat is the difference between a unitized frame and a uni-body? - ANSWER-There is no difference. In a uni-body or unitized vehicle, the frame and body are incorporated into a single welded structure. Should exhaust damaged systems be welded and repaired, or replaced all together? - ANSWER-Replace...
Technician A only - ANSWER-A technician connects one lead of a DMM (digital multimeter) to the positive (+) terminal of a battery and the other meter lead to the "B" terminal of the starter solenoid and then cranks the engine. During cranking, the voltmeter displays a reading of 878 mV. Techni...
Preview 4 out of 38 pages
Add to cartTechnician A only - ANSWER-A technician connects one lead of a DMM (digital multimeter) to the positive (+) terminal of a battery and the other meter lead to the "B" terminal of the starter solenoid and then cranks the engine. During cranking, the voltmeter displays a reading of 878 mV. Techni...
OBD2 P C B U - ANSWER-Body Chassis Power U-Network VM - ANSWER-connected in parallel Ammeter - ANSWER-connected in series or can damage OBD2 First Digit - ANSWER-0-Universal 1-OEM 2nd digit system Short within component - ANSWER-resistance less than spec short to power - ANSW...
Preview 2 out of 7 pages
Add to cartOBD2 P C B U - ANSWER-Body Chassis Power U-Network VM - ANSWER-connected in parallel Ammeter - ANSWER-connected in series or can damage OBD2 First Digit - ANSWER-0-Universal 1-OEM 2nd digit system Short within component - ANSWER-resistance less than spec short to power - ANSW...
An air bag system is being serviced, Technician A says to disconnect the yellow SRS connectors at the front of the vehicle. Technician B says to disconnect and isolate the negative battery cable. Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B - ANSW...
Preview 3 out of 20 pages
Add to cartAn air bag system is being serviced, Technician A says to disconnect the yellow SRS connectors at the front of the vehicle. Technician B says to disconnect and isolate the negative battery cable. Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B - ANSW...
Definition of ASE certification - ANSWER-program that prepares a person to take a written test to prove their knowledge in automotive technology. ASE board of directors - ANSWER-They make sure you pass the test 8 categories in the test - ANSWER-engine repair, automotive transmission,manual dri...
Preview 1 out of 2 pages
Add to cartDefinition of ASE certification - ANSWER-program that prepares a person to take a written test to prove their knowledge in automotive technology. ASE board of directors - ANSWER-They make sure you pass the test 8 categories in the test - ANSWER-engine repair, automotive transmission,manual dri...
A - ANSWER-A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C - ANSWER-A vehicle is equipped with a hydro-boost brake system has a hard pedal with little b...
Preview 2 out of 7 pages
Add to cartA - ANSWER-A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C - ANSWER-A vehicle is equipped with a hydro-boost brake system has a hard pedal with little b...
C - ANSWER-What would a C-clamp be used for during disc brake service? A. Seating the pads on the rotor B. Seating the caliper on the guides C. Retracting the piston in the bore D. Compressing the pads into the piston D - ANSWER-The red brake warning light illuminates when the brake pedal is ...
Preview 2 out of 7 pages
Add to cartC - ANSWER-What would a C-clamp be used for during disc brake service? A. Seating the pads on the rotor B. Seating the caliper on the guides C. Retracting the piston in the bore D. Compressing the pads into the piston D - ANSWER-The red brake warning light illuminates when the brake pedal is ...
A spongy brake pedal may be caused by: a. ABS Diagnostic Trouble Code set b. Frozen caliper piston c. Defective metering valve. d. Air in hydraulic system - ANSWER-D This question is not like the others. It has the word EXCEPT. For this question, look for the choice that could NOT cause the d...
Preview 2 out of 5 pages
Add to cartA spongy brake pedal may be caused by: a. ABS Diagnostic Trouble Code set b. Frozen caliper piston c. Defective metering valve. d. Air in hydraulic system - ANSWER-D This question is not like the others. It has the word EXCEPT. For this question, look for the choice that could NOT cause the d...
an engine miss is being diagnosed using a cylinder leakage test. Technician A says that any cylinder with over 20% leakage has excessive leakage. Tech B says that air leaking from the tailpipe indicates a cracked cylinder. A only, B only, A & B, Neither . - ANSWER-A only: If cylinder lea...
Preview 4 out of 47 pages
Add to cartan engine miss is being diagnosed using a cylinder leakage test. Technician A says that any cylinder with over 20% leakage has excessive leakage. Tech B says that air leaking from the tailpipe indicates a cracked cylinder. A only, B only, A & B, Neither . - ANSWER-A only: If cylinder lea...
Failing transmission oil pump? Why important symptoms - ANSWER-A transmission oil pump is an integral part of the transmission unit. It serves the critical purpose of providing lubrication to the valve body and other essential internal tranny components. It also transports transmission fluid to the ...
Preview 2 out of 5 pages
Add to cartFailing transmission oil pump? Why important symptoms - ANSWER-A transmission oil pump is an integral part of the transmission unit. It serves the critical purpose of providing lubrication to the valve body and other essential internal tranny components. It also transports transmission fluid to the ...
A diesel engine is using too much oil. All of the following could be the cause EXCEPT A. Worn piston rings B. Worn valve guides C. Worn valve seats D. Loose oil pan fasteners - ANSWER-C. Worn valve seats (work valve seats can cause low compression, but will not cause oil consumption) Which...
Preview 2 out of 13 pages
Add to cartA diesel engine is using too much oil. All of the following could be the cause EXCEPT A. Worn piston rings B. Worn valve guides C. Worn valve seats D. Loose oil pan fasteners - ANSWER-C. Worn valve seats (work valve seats can cause low compression, but will not cause oil consumption) Which...
A - ANSWER-The brakes are dragging on a vehicle. This could be caused by: A. Overfilled master cylinder reservoir. B. Low vacuum to the booster. C. Bypassing master cylinder. D. Quick take-up valve stuck open. B - ANSWER-The brake pads are worn at an angle on a vehicle with a sliding brake ca...
Preview 2 out of 6 pages
Add to cartA - ANSWER-The brakes are dragging on a vehicle. This could be caused by: A. Overfilled master cylinder reservoir. B. Low vacuum to the booster. C. Bypassing master cylinder. D. Quick take-up valve stuck open. B - ANSWER-The brake pads are worn at an angle on a vehicle with a sliding brake ca...
2. A driver says that the front end of his car vibrates up and down while traveling at most road speeds. Tech A says that too much runout of the front wheels could be the cause. Tech B says that a static out of balance of the front wheels could be the cause. Who is right? A. Tech A only B. Tech B ...
Preview 3 out of 19 pages
Add to cart2. A driver says that the front end of his car vibrates up and down while traveling at most road speeds. Tech A says that too much runout of the front wheels could be the cause. Tech B says that a static out of balance of the front wheels could be the cause. Who is right? A. Tech A only B. Tech B ...
Tech A says that evacuating an AC system will remove air and moisture from the system. Tech B says evacuating an AC system removes dirt particles. Who is right? - ANSWER-A. Evacuating the system removes air and moisture. The receiver drier may contain a filter or strainer to catch and trap foreign p...
Preview 2 out of 12 pages
Add to cartTech A says that evacuating an AC system will remove air and moisture from the system. Tech B says evacuating an AC system removes dirt particles. Who is right? - ANSWER-A. Evacuating the system removes air and moisture. The receiver drier may contain a filter or strainer to catch and trap foreign p...
1x sold
A CCOT system has a high high side. Technician A says to suspect the thermostatic expansion valve. Technician B says this system contains an orifice tube. Who is correct? - ANSWER-TECH B is correct. A clogged orifice tube will result in high high side pressure. It can become clogged with contaminant...
Preview 2 out of 6 pages
Add to cartA CCOT system has a high high side. Technician A says to suspect the thermostatic expansion valve. Technician B says this system contains an orifice tube. Who is correct? - ANSWER-TECH B is correct. A clogged orifice tube will result in high high side pressure. It can become clogged with contaminant...
The opening temperature - ANSWER-A thermostat is rated at 195°F. This means: a. The opening temperature b. The fully open temperature c. The temperature in the radiator before the thermostat opens d. The temperature that the cooling fan comes on Cause the vehicle to burn more gas than if he ...
Preview 1 out of 3 pages
Add to cartThe opening temperature - ANSWER-A thermostat is rated at 195°F. This means: a. The opening temperature b. The fully open temperature c. The temperature in the radiator before the thermostat opens d. The temperature that the cooling fan comes on Cause the vehicle to burn more gas than if he ...
spark plug wire resistance should be - ANSWER-5000 to 10000 ohms how do you test spark plug cables insulation - ANSWER-spray it with salt water The specification, such as 10 BTDC, indicates that - ANSWER-indicates that the spark occurs at 10 degrees before top dead center of the compression st...
Preview 2 out of 13 pages
Add to cartspark plug wire resistance should be - ANSWER-5000 to 10000 ohms how do you test spark plug cables insulation - ANSWER-spray it with salt water The specification, such as 10 BTDC, indicates that - ANSWER-indicates that the spark occurs at 10 degrees before top dead center of the compression st...
High Hydro Carbons indicate... - ANSWER-Engine misfire; Incomplete burning of fuel, Ignition fault Lean misfire Thermostat (engine temp. too low) High CO indicates... - ANSWER-Rich condition; Leaking fuel injector or fuel-pressure regulator Clogged air filter or PCV system Excessive fuel pr...
Preview 1 out of 3 pages
Add to cartHigh Hydro Carbons indicate... - ANSWER-Engine misfire; Incomplete burning of fuel, Ignition fault Lean misfire Thermostat (engine temp. too low) High CO indicates... - ANSWER-Rich condition; Leaking fuel injector or fuel-pressure regulator Clogged air filter or PCV system Excessive fuel pr...
If the compression is 5 psi and the oem spec is 140 psi, what most likely is the cause? A, worn piston ring. B, burnt valve. - ANSWER-Both A and B What most likely is the cause if the compression doesn't go up during a wet compression test? A, burnt valve. B, worn piston ring. - ANSWER-A...
Preview 2 out of 9 pages
Add to cartIf the compression is 5 psi and the oem spec is 140 psi, what most likely is the cause? A, worn piston ring. B, burnt valve. - ANSWER-Both A and B What most likely is the cause if the compression doesn't go up during a wet compression test? A, burnt valve. B, worn piston ring. - ANSWER-A...
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
You can quickly pay through credit card for the summaries. There is no membership needed.
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Stuvia is a marketplace, so you are not buying this document from us, but from seller CLOUND. Stuvia facilitates payment to the seller.
No, you only buy these notes for £28.46. You're not tied to anything after your purchase.
4.6 stars on Google & Trustpilot (+1000 reviews)
80796 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy revision notes and other study material for 14 years now