General Crane Knowledge B, C, and E NCCCO Study Questions and Answers-100% Accurate.

standards for crane safety can be found in - ANSWER-a. 29 cfr 19 subpart cc which of the following is an employer requirement - ANSWER-d. all of the above you must assure your crane is stable by each except - ANSWER-b on-board seismograph load charts must - ANSWER-b. indicate rated lifting capac...

A crane is operating with a long boom, on outriggers, on uneven ground. Under these conditions it is important to - ANSWER-Block under the float or pad to achieve a 90 degree angle between the cylinder rod and the float or pad What is the purpose of a boom length indicator? - ANSWER-Indicates the...

NAVFAC P-307 Training - 144 Questions and answers What types of power does a category 1 or 4 crane generally use and what is it's source? A hook is what type of component? Load-bearing part Hydraulic foot brakes are what type of group of components Load-controlling parts Load-_____ parts are...

General crane safety-122 Questions and Answers-100% Accurate. The minimum crane team for a mobile crane on outriggers would consist ofA) The Crane Operator, Rigger Supervisor, and Crane Rigger B) The Crane Operator, Crane Supervisor, Rigger Supervisor, and Crane Rigger C) The Crane Operator, Cr...

General Crane Knowledge B, C, and E NCCCO Study Questions and Answers-100% Accurate. According to ASME B30.5 regulations require a signal person to observe power line clearances when the; A. The crane is within a booms reach of the prohibited zone B. When the power line is over 350kV C. When ...

EICA Crane Certification test study guide questions with correct answers OSHA 1926 applies to construction law OSHA sub part CC Construction law pertaining to cranes ASME B30.5 Mobile and Locomotive cranes ASME B30.9 standard on slings ASME B30.10 standard on hooks ASME B30.23 standard...

Cranes Test - 181 questions and answers - 100% accurate How many months at a maximum do personnel have to qualify as a maintenance technician? - ANSWER-3 Floating cranes, aircraft-crash cranes, and virtually all pierside cranes are under the cognizance of what? - ANSWER-NAVFAC What is a shock ...

Crane Test Questions And Answers Solved 100% Correct 2023/2024. Which statement best describes the importance OSHA 1926.1400 places on manufacturers' instructions, specifications, and limitations? - ANSWER-They shall be followed exactly as the law According to OSHA 1926.1422, where must hand s...

A crane should be level within: - ANSWER-10 degrees Exceeding the maximum counterweight approved by the manufacturer for use on a crane: - ANSWER-May cause structural damage and/or turn the crane over backwards On a pick and carry operations, you should: - ANSWER-Keep the boom as short as possib...

Crane Safety and Rigging CEE 4120 - Exam 3 Questions and Answers-100% Accurate. What is the most common reason for crane-related fatal accidents? - ANSWER-Powerlines and then being struck by the crane load How do you escape an energized crane? - ANSWER-The whole body needs to stay in one spot....

Which of the following can affect the crane's capacity? - ANSWERThe horizontal distance from the center of rotation of the crane to the center of the hoist lines w/ load applied: - ANSWER-Radius A crane accident occurs when any element of the crane operating envelope fails to perform correctly d...

CATEGORY 3 NON-CAB OPERATED TEST QUESTIONS WITH 100% ACCURATE ANSWERS Bridge cranes with rated capacities of 20,000 lbs. or greater are classified as ______ cranes - answer-Category 2 The expiration date that is of particular importance to crane operators is - answer-The certification expirati...

Category 3 Non-Cab Operated Crane Safety Questions And Answers Solved 100% Correct 2023/2024. A floating crane with a capacity of 200,000lbs. is a ________________ crane. - ANSWER-Category 1 What is the category of a jib crane with a capacity of less than 20,000 pounds? - ANSWER-Category 3 An...

When should a tag line be used? When rotation of the load may be dangerous 3 multiple choice options Which of the following is a cause for boom deflection? Lifting a heavy load 3 multiple choice options which of the following would be deductions when calculating parts of line? load weight, ri...