Power Engineering Success Bundle 2024!!

Where gear teeth inter-mesh, a lubricant must provide: a. corrosion prevention b. sealing c. shock absorption d. temperature control - Answer c The majority of lubricants are: a. animal fats b. synthetic oils c. mineral oils d. greases - Answer c The kind of grease used for heavily...

Which of the following is an example of a loss of latent heat? a. steam condenses b. water evaporates c. ice melts d. refrigerant evaporates - Answer a Heat that causes an increase in temperature is called _____ heat. a. radiant b. sensible c. latent d. convective - Answer b The sa...

Two canadadian codes which have been adopted by all canadian jurisdictions and which are of importance to fifth class power engineering are the: - Answer CSA B51 And B52 The ASME code sections which are most pertinent to Fifth and Fourth class power engineer are sections: - Answer IV and VI ...

Actuator - Answer A device to produce physical movement based on output from a computer system. Operated by electric current, hydraulic fluid pressure, or pneumatic pressure. Analog - Answer A continuous method of representing information. Analog to Digital Convertor - Answer Converts an...

e - Answer Impulse turbines: Choose one answer. a. are only used with low pressure steam b. require large thrust bearings c. were invented by Parsons d. have large pressure drops across the huckets e. have blades with the same steam inlet and outlet angles d - Answer The stationary ...

Which activity does not use steam? a. heavy oil recovery b. computer chip manufacturing c. removing skin from potatoes d. refrigeration systems - Answer b The holder of a Certificate of Competency, the classification of which authorizes him or her to act as a engineer, may sketch, construct...

3 defined groups/categories of Metallurgy? - Answer - Extractive - Mechanical - Physical Define 'Extractive' Metallurgy. - Answer - The study of extraction and purification of metals from their ores. This includes a stepped process which can utilize Pyrometallurgy, Hydrometallurgy or E...

When applying to write a Power Engineer certificate of competency examination, the candidate must: Select one: a. Undergo mandatory drug testing b. Hold the next lower class of qualification c. Pass a criminal records check d. Pass both a written and oral examination - Answer b. Hold the next ...

The boilers and pressure vessels act was put into place to protect: a) contractors b)owners c)employers d)employees e) the public - Answer e Which of the following codes have the Canadian jurisdictions adopted in reference to pressure vessel regulation? a)CBT V33 b)CBT V62 c)CSA B51 d)...

Velocity (m/s) - Answer Change in position / time Acceleration (m/s^2) - Answer Change in velocity (m/s) / time (s) Force (Newton) - Answer mass (kg) x acceleration (m/s^2) , any action on a body that tends to change its size, shape, or its state of rest or motion Force of Gravity - A...

A typical natural gas flame should be: a. blue, with orange at the tip of the flame b. asymmetrical, and as close as possible to the heat transfer surfaces. c. bright yellow, with black tips. d. bright yellow, with orange tips. - Answer a Which of the following is NOT done when preparing ...

External heat gains include those by: - Answer Infiltration, Ventilation and Solar radiation A wind velocity of _______________ is used to calculate the winter infiltration heat loses - Answer 24 km/h ( 15mph ) The heat given off by light fixtures is not greatly affected by the: - Answer ...