FANUC Certification Questions and Verified Answers Pack | Passed | A+

Turning the Teach Pendant On: : Gives motion control solely to the operator via the Teach Pendant What must be accomplished to avoid hard-stops and over-travels? : Set Axis Limits SHIFT and the hardkey COORD will display the following menu: : The "jog" menu SHIFT and POINT are needed to do w...

Enabling the iPendant gives motion control solely to whom? : OPERATOR Assuming standard setup, if you jog the robot in world Y- which direction will the TCP move? : ROBOT'S RIGHT Which key is depressed to switch between the different jog methods? : COORD What two buttons display the jog men...

What combination is used to record a program point : Shift point When creating a program which hard key should be pressed : Select Shift and the hard key COORD will display the following menu : "Jog" menu In motion command if you want to change joint to linear what do you press : Component ...

List the Major Axis : J1, J2, J3 List the Minor Axis : J4, J5, J6 Identify the Components of the SOP : 1. Fault Reset 2. Cycle Start 3. Fault LED 4. Power LED 5. E-STOP 6. Mode Switch 7. Hour Meter 2 Which mode limits all cartesian speed to less than 250 mm/sec and joint speed to less...

Enabling the iPendant gives motion solely to whom? A. The PLC B. The Controller C. The Operator : C Assuming standard setup, if you jog the robot in World -Y, which direction will the TCP move? A. Straight out front B. Up C. To the robots right D. To the robots left : C 2 What key is d...

Turning the Teach Pendant on: : Gives motion control solely to the operator via the teach pendant What must be accomplished to avoid hard-stops and over travels? : Set Axis Limits SHIFT and the hard key COORD will display the following menu: : The "jog" menu SHIFT and POINT are needed to do ...