EPA 608 (TYPE II) Exam
When a new system has been assembled, the first thing to do is? - ANSPressurize the system
with an inert gas & leak check.
After installation of a field-piped R-410A split heat pulp, the unit should first be? -
ANSPressurized with nitrogen then leak checked.
The EPA regulations require that any appliances containing more than 50 pounds of refrigerant
(except for commercial & industrial process refrigeration) must be repaired when the leak rate
exceeds _________ of the charge per year? - ANS15%
R-410A requires recovery tanks rated for at least? - ANS400 psig
After refrigerant liquid has been recovered from a system, any remaining vapor is? -
ANSCondensed by the recovery system.
Your recovery/recycling machine has R-502 refrigerant in it. You now have to recover refrigerant
from a unit with R-22. What must be done before the R-22 refrigerant can be
recovered/recycled? - ANSRecover as much R-502 from the recovery unit as possible, change
filter, & evacuate.
In a refrigeration system with a TXV (or other type of throttling device), the component directly
following the condenser is the? - ANSReceiver
When charging an R-410A system that uses a water-cooled condenser, you must first charge
with vapor to a pressure of at least________, before switching to liquid charging. - ANS120 psig
Recovered refrigerant may contain what? - ANS1.) Acids
2.) Moisture
3.) Oils
Your recovery/recycling machine has R-22 refrigerant in it. You now have to recover refrigerant
from a unit with R-410A. What must be done before your recovery unit can be used to recover
R-410A? - ANS1.) The recovery unit must be EPA certified for use with R-410A.
2.) The recovery tank must be designed for the pressure of R-410A.
3.) The filter & lubricant in the recovery unit must be changed, & the recovery unit evacuated.
, To recover liquid refrigerant, you must connect one hose to the? - ANSLiquid Line.
The proper charging method for blended (non-azeotropic) refrigerants (400 Series) is to use a
remove the charge from the cylinder as a? - ANSLiquid
Before using a recovery unit to remove a charge, what steps should be taken? - ANS1.) Check
service valve positions.
2.) Check the oil level in the recovery unit.
3.) Evacuate recovery unit & recovery tank.
On refrigeration units that use an open compressor; the ________ is most likely to leak if the
unit is not used for several months. - ANSThe rotating shaft seal.
Noncondensables in a system cause? - ANSHigher discharge pressure.
Heat Pumps that use R-410A should be leak checked with? - ANSPressurized Nitrogen.
A reciprocating compressor should not be energized when? - ANSThe discharge service valve
is closed.
In a refrigeration system, the component directly following the evaporator is the? -
ANSAccumulator.
Manifold gauge set hoses should have self-sealing connectors or hand valves to? -
ANSMinimize the release of refrigerant when the hoses are connected & disconnected.
The EPA regulations require that leaking commercial or industrial process refrigeration
equipment must be repaired when the leak rate exceeds _____ of the charge per year. -
ANS35%
Moisture is removed from a system by? - ANSUsing a filter drier.
Oil foaming usually occurs in the? - ANSCompressor
R-410A is different from other ASHRAE 400 series non-azeotropic blends because? -
ANSR-410A behaves as a near azeotropic refrigerant, & can be topped off.
With an air-cooled condenser on the roof of a building & the evaporator on the first floor,
recovery should first occur? - ANSFrom the liquid line entering the evaporator.
A deep vacuum is usually measured in? - ANSMicrons.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Ashley96. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for £8.15. You're not tied to anything after your purchase.