100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Rigging 101 Final Exam 2024/2025 already graded A+ 2024/2025 £9.34   Add to cart

Exam (elaborations)

Rigging 101 Final Exam 2024/2025 already graded A+ 2024/2025

 10 views  0 purchase
  • Module
  • GENERAL CRANE SAFETY
  • Institution
  • GENERAL CRANE SAFETY

Rigging 101 Final Exam 2024/2025 already graded A+ 2024/2025

Preview 2 out of 5  pages

  • February 29, 2024
  • 5
  • 2023/2024
  • Exam (elaborations)
  • Questions & answers
  • GENERAL CRANE SAFETY
  • GENERAL CRANE SAFETY
avatar-seller
Rigging 101 Final Exam

Oxygen bottles that are properly secured in a rack or stand designed for lifting/handling would
be considered a critical rigging option. - ANSfalse

There are three slings hanging from a hook. Each sling has the capacity of 2,000 pounds. What
is the heaviest load that could be lifted using these slings if they were attached to a single point?
- ANS2,000 lbs

The minimum depth of thread engagement for a 1/2 inch eyebolt into a steel object is: - ANS3/4"

Given a 1/2 in steel walled empty cylindrical tank that is opened at one end, calculate its weight
(round answer to the nearest hundred). - ANS1800

What markings are required on hoists? - ANSthe manufacturer, model number, rated load, and
re-inspection due date

Which of the following markings are required on lashing? - ANSthe reinspect due date, rated
load

A motor that weighs over 80 of the capacity of the rigging gear used in the rigging operation is
considered a critical rigging operation is considered a critical rigging operation. - ANSfalse

Increasing the sling angle from horizontal _______ the stress in the sling. - ANSdecreases

The area of this triangle with dimensions given in feet is: - ANS24 sqft

What is the minimum grade of chain required for chain slings? - ANSgrade 80

Two people should be used to pull the hand chain of a manual chain hoist when it gets too hard
for on person to pull. - ANSfalse

Sling angle stress could contribute to an overload even if the slings selected had enough
capacity to carry the total load weight. - ANStrue

Which of the following attachment points can be used at full capacity when pulled at any angle
from vertical? - ANSswivel hoist rings

To find sling angle stress... - ANSmultiply the weight in the attachment point with the angle
factor

, Who is required to perfom an inspection prior to using rigging gear, and what is this inspection
called? - ANSthe user, pre-use inspection

Detailed written procedures are required for every rigging operation. - ANSfalse

The rigging operating envelope contains the rigging gear and miscellaneous equipment covered
by P-307 section 14, the load itself and... - ANSthe load rigging path, the gear or equipment's
supporting structure

When a load is left suspended unattended from a chain hoist it must be secured. How is the
chain hoist secured - ANSthe chain is tied off or pad locked

What is the efficiency of a knot or bend? - ANS75

Never bend a wire rope around a diameter _______ itself. - ANSsmaller than

To whom or to what are the majority of crane and rigging accidents attributed? - ANSpersonnel
error

What is the name of the knot or hitch shown below? (blue rope) - ANSclove hitch

a straight-line hitch is good for _____ of a sling rated load? - ANS100%

What must be used to tighten a swivel hoist ring to the manufacturer's requirements? - ANSa
torque wrench

Attachment point #1 is 6 feet from the center of gravity (CG) and attachment point #2 is 3 feet
from the center of gravity (CG). There is a 10,000 lbs load attached. What is the correct
equation to find the weight distribution for attachment point #1? - ANS3 divided by 9 multiplied
by 10,000 ( x 10,000)

It is ok to tie a know in or install a bolt into a chain sling leg to shorten the sling. - ANSfalse

When rigging gear covered by p-307 section 14 fails while suspended from a structure and
drops the load it is a: - ANSrigging accident

Why must hoisting be stopped once the load is completely off the ground? - ANSto determine
sling angle stress

Distorted or twisted rigging hardware must be: - ANSremoved from service

For all critical rigging operations, a supervisor must review on-site conditions and... -
ANSconduct a pre-job briefing

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller Ashley96. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for £9.34. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

75323 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy revision notes and other study material for 14 years now

Start selling
£9.34
  • (0)
  Add to cart