On a port fuel-injected engine, the cause of excessive black smoke in the exhaust
could be:
`low fuel pressure
`an intake manifold vacuum leak
`high oxygen sensor voltage
`high fuel pressure - High fuel pressure
During a cylinder power balance test on a four-cylinder port fuel-injected engine,
one cylinder has a 75-rpm drop and the other cylinders have a 125-rpm drop.
Technician A says that the cylinder with a 75-rpm drop may have a burned
exhaust valve. Technician B says that the cylinder with the 75-rpm drop may have
a bad fuel injector. Who is correct?
A only
B only
Both A and B
Neither A nor B - Both A and B
While discussing cylinder head service, Technician A says that torque-to-yield
bolts may be reused if they are not damaged. Technician B says that
torque-to-yield bolts are usually tightened to a specific torque and then rotated a
certain number of degrees. Who is correct?
A only
B only
Both A and B
Neither A nor B - B only
The cause of excessive valve stem height could be:
, `An improperly installed valve guide
`excessive material machined from the head surface
`a worn valve guide and stem
`excessive material removed from the valve seat - excessive material removed
from the valve seat
While diagnosing an engines timing belt condition, Technician A says that some
vehicle manufacturers recommend checking timing belt wear by measuring the
installed length of the belt tensioner. Technician B says that on some engines the
valves will strike the top of the pistons if the timing belt jump breaks. Who is
correct?
A only
B only
Both A and B
Neither A nor B - Both A and B
While discussing engine sealants, Technician A says that RTV sealer dries in the
absence of air. Technician B says that anaerobic sealer dries in the absence of air.
Who is correct?
A only
B only
Both A and B
Neither A nor B - B only
While measuring cylinder taper and out-of-round, Technician A says that the
cylinder diameter should be measured at two vertical locations. Technician B
says that cylinder our-of-round is the difference between the cylinder diameter in
the thrust and axial directions. Who is correct?
A only
B only
Both A and B
Neither A nor B - B only
Technician A says that when checking connecting rods, they should be measured
to determine if they are bent. Technician B says that each connecting rod should
be measured for a twisted condition. Who is correct?
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller ACTUALSTUDY. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for £6.46. You're not tied to anything after your purchase.