Boiler Exam Practice Tests
removes sludge and sediment from the mud drum - ANS-The bottom blowdown on a boiler ___.
outside diameter - ANS-Boiler tubes are sized using the ___.
tin - ANS-A boiler fusible plug is brass or bronze with a core of ___.
hairline cracks in the refractory - ANS-Spalling in a boiler refers to ___.
34.5 - ANS-Boiler horsepower is the evaporation of ___ lb of water/hr from and at a feedwater
temperature of 212°F.
steam temperature - ANS-A siphon installed between the boiler and the pressure gauge
protects the Bourdon tube from___.
10 to 11.5 - ANS-The pH of the boiler water should be ___.
steam leaving the boiler - ANS-The boiler superheater raises the temperature of the ___.
feedwater - ANS-An economizer is used to preheat ___.
oily waste rags - ANS-Fires caused by spontaneous combustion would probably start in the ___.
dirty strainers - ANS-A high suction reading on the fuel oil pressure gauge indicates ___.
try cock - ANS-The ___ is a secondary means of determining boiler water level.
pyrometer - ANS-A(n) ___ is used to measure furnace temperature.
1 ½ - ANS-The range of a boiler pressure gauge must not be less than ___ times the safety
valve setting.
prevent formation of scale - ANS-Boiler feedwater is chemically treated to ___.
deadweight tester - ANS-Pressure gauges are calibrated with a(n) ___.
inside tube surface - ANS-In a firetube boiler, soot settles on the ___.
complete - ANS-Carbon dioxide in the flue gas is a sign of ___ combustion.
incomplete - ANS-Carbon monoxide in the flue gas is a sign of ___ combustion.
,Globe - ANS-___ valves should be used for throttling service.
a dirty heating surface - ANS-A gradual increase in chimney temperature indicates ___.
1 ½ - ANS-The pressure applied on the boiler during a hydrostatic test is ___ times the MAWP.
6 - ANS-Boiler safety valve capacity must be such that the steam pressure can never go higher
than ___% above the MAWP.
decreased - ANS-As fuel oil is heated, its viscosity is ___.
6 - ANS-No. ___ fuel oil has the highest Btu content per gallon.
T - ANS-T/F All steam boilers must have one or more safety valves.
T - ANS-T/F An open feedwater heater vents gases to the atmosphere.
F - ANS-T/F A hydrostatic test will determine whether a steam boiler has sufficient relieving
capacity.
T - ANS-T/F When boilers are set in battery, the main steam stop valves, bottom blowdown
valves, and feedwater valves should be locked closed before anyone enters the boiler drums.
F - ANS-T/F Open and closed feedwater heaters are never used at the same time.
T - ANS-T/F In an open feedwater heater, the water and steam come into direct contact; in a
closed feedwater heater, the water and steam are separated.
T - ANS-T/F An economizer is a fuel-saving device that reclaims heat from the gases of
combustion.
F - ANS-T/F Soot accumulation on the tubes of a watertube boiler does not affect the efficiency
of the boiler.
F - ANS-T/F Scale protects the boiler heating surfaces.
F - ANS-T/F Boiler corrosion cannot be prevented as long as water is in contact with metal.
T - ANS-T/F To prevent water hammer, water should be drained out of all high pressure steam
lines
T - ANS-T/F Dry saturated steam is in a gaseous state.
F - ANS-T/F Pressure on water does not change the boiling point of the water.
, F - ANS-T/F The stop valve in a boiler feedwater line should have the pump discharge pressure
on the top of the valve disc when the valve is closed.
T - ANS-T/F According to the ASME Code, weighted lever safety valves cannot be used on
boilers.
F - ANS-T/F The interior of the Bourdon tube in a steam pressure gauge is always filled with live
steam when it is operating.
T - ANS-T/F Safety valves on superheaters should be set to open before main safety valves on
boilers.
T - ANS-T/F When air preheaters or economizers are used in a boiler, induced draft is usually
employed.
T - ANS-T/F Waterwalls permit greater heat absorption per cubic foot of furnace volume than
refractory walls.
T - ANS-T/F A steam trap is a device that removes air and condensate without loss of steam.
F - ANS-T/F Steam traps are only used on high-temperature hot water systems.
T - ANS-T/F Steam traps are used wherever condensate collects.
F - ANS-T/F A boiler feedwater pump cannot become steambound.
F - ANS-T/F In both firetube and watertube boilers, the fire is inside the tubes.
T - ANS-T/F Foaming can lead to carryover.
Steam entering the huddling chamber exposing a larger area for the steam pressure to act on -
ANS-___ makes a pop-type safety valve pop open.
pulling the test lever by hand and then releasing it to allow it to "snap" closed - ANS-Manual
testing of the safety valve is accomplished by ___.
a mixture of water and steam - ANS-The middle try cock should be mounted at the NOWL and,
when operated, should blow ___.
soot blowers - ANS-To ensure good heat transfer in a watertube boiler, the outside of the tubes
are kept clean by ___.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller ACTUALSTUDY. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for £6.46. You're not tied to anything after your purchase.
