100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
3rd class stationary steam engineer license prep Exam/250 Q’s and A’s £9.89   Add to cart

Exam (elaborations)

3rd class stationary steam engineer license prep Exam/250 Q’s and A’s

 1 view  0 purchase

3rd class stationary steam engineer license prep Exam/250 Q’s and A’s

Preview 3 out of 16  pages

  • September 23, 2024
  • 16
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
All documents for this subject (2)
avatar-seller
Victorious23
3rd class stationary steam engineer
license prep Exam/250 Q’s and A’s
time, temperature, mixture, and atomization - - _________ are necessary for
complete combustion

- 214.7 - - if the steam pressure gauge indicates 200 PSIG, the absolute
pressure is______

- 12 - - a boiler is operating at 400 PSI, and the safety valve opens at 410
PSI and closes at 398 PSI. The blowdown is______psi

- steam turbine - - an oil cooler is commonly used with a(n) ________ when
operating in conjunction with a turbo-generator

- superheated - - a boiler is producing 40,000lb of steam/hr at a pressure of
100 PSI and a steam temperature of 500 degrees Fahrenheit. The steam
produced is _______ steam

- add heat to the feed water - - the economizer on a boiler is used to _______

- water tube - - blowers are normally used with________ boilers

- scale on tubes - - overheating of tubes on a boiler can be caused
by________

- channeling - - carbon dioxide in a condensate return system
causes_________

- reciprocating - - a ________ pump is a positive displacement pump

- 6,000,000 - - a boiler generating 6000 lb of steam/hr produces
_______btu/hr

- discharge sludge and sediment - - a bottom blowdown is performed on a
boiler to _____

- 1 - - water columns are connected to the boiler with a minimum of _______"
pipe

- 3/4 - - the minimum size of a water column blowdown valve is_______".

- 2 1/2 - - the maximum size bottom blowdown valve on a boiler
is_________".

, - a steam trap - - a ________ allows condensate to pass through, but stops
Steam.

- water level in each boiler - - when taking over a shift, the first thing to do
is check the________

- two or more safety valves - - according to the asme code, a high-pressure
boiler having more than 500 square feet of heating surface shall
have________

- dirty heating services - - the probable cause of an increase in temperature
of gases of combustion at the boiler Outlet is____

- manhole openings - - boilers in battery equipped with________ must have
two main steam stop valves and a free-flowing drain between them

- blowdown the gauge glass - - in order to be sure the gauge glass is
indicating an accurate water level reading, the stationary engineer
should______

- in the Steam and water drum well below the nowl - - a continuous
blowdown line is located___

- 176 - - a temperature reading of 80 degrees Celsius is equal to_________°f

- poor efficiency - - a chimney temperature of 250 degrees Fahrenheit
above steam temperature indicates_______

- inches of water - - a manometer is red in________

- be raised - - the boiling point of water will____ with an increase in pressure

- hard - - if a lather is not obtained when performing a soap hardness test,
the water sample is_______

- preheated - - combustion efficiency can be increased when air is________

- induced - - ______ draft is produced by a fan located between the boiler
and the chimney

- before putting the steam turbine on-line - - the overspeed trip on a steam
turbine should be tested ______

- High combustion efficiency - - a high CO2 reading in the gases of
combustion is a sign of____

, - turn scale-forming salts to a non adhering sludge - - the purpose of
chemically treating feedwater is to________

- Loop seal or internal overflow - - water in a d rating feed water heater is
prevented from entering the steam line by a(n) _______.

- 3960 - - a steam turbine operating at 3600 RPM will trip at_________ rpm

- steam drum - - he steam line going to The Blowers is connected to the
main ________

- drain set blower lines - - before using blowers on a boiler,________

- decreases boiler efficiency - - an accumulation of snow on the Fireside of a
boiler tubes________

- under - - a globe valve installed in the feed water line between the feed
water pump and boiler has a pressure from the feed water pump_________
the valve disc

- 1 1/2 - - the range of a pressure gauge should be twice the safety valve
setting, but not less than______ time (s) the safety valve setting

- air- or water-driven turbines - - hard scale formed on the inside of tubes is
best removed by________

- secure fires - - to correct a low water condition,_____

- establish steam flow - - desuperheater drain is used to_______

- there is a broken baffle - - a sudden rise in chimney temperature with no
increase in load indicates______

- 100,000 btu/therm - - the btu content of natural gas is_____

- higher than - - the safety valve setting on the Steam and water drum is
________ a superheater safety valve

- 18750 BTU / lb - - the btu content of number 6 fuel oil is approximately

- proportioning - - chemicals can be added to a boiler by a______pump

- boiler and check valve - - the feed water stop valve is found between
the____

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller Victorious23. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for £9.89. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

82265 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy revision notes and other study material for 14 years now

Start selling
£9.89
  • (0)
  Add to cart