Exam (elaborations)
Electrical Theory Exam 2024/2025 Questions With Completed & Verified Solutions.
- Module
- Institution
Electrical Theory Exam 2024/2025 Questions With Completed & Verified Solutions.
[Show more]
Seller
Follow
ALICE12
Reviews received
Content preview
Electrical TheoryState the permissible test result for an insulation resistance test for the electrical installation with
ALL the permanently-connected electrical equipment DISCONNECTED - ANS 1 Mega Ohm
State the permissible test result for an insulation resistance test for the electrical installation with
ALL the permanently-connected electrical equipment CONNECTED - ANS 0.01 Mega Ohms
A three-phase induction motor normally runs on full-load. State ONE reason why this motor
should not be run LIGHTLY LOADED when it runs on full load. - ANS - The power factor of the
motor will be poor
- The motor will be less efficient
- running costs rise
A three-phase induction motor has been OPERATING NORMALLY ON FULL-LOAD. The motor
starts to over-heat even though it is drawing the normal full load current.
State ONE reason why this situation would occur - ANS - The motor ventilation is restricted in
some manner
- The cooling fan has become detached from the motor shaft
A clip-on ammeter is being used to test the integrity of the insulation of a repaired Class I
electrical appliance, while the appliance is live. Where on the appliance would the clip-on
ammeter be used? Also state the maximum test result that would allow the appliance to return
to service. - ANS Clamped around the protective earthing conductor and 5mA
Explain what is meant by the term INVERSE TIME-CURRENT CHARACTERISTIC in relation to
protective devices - ANS as current through the protective device increases, the time taken to
operate decreases
State TWO components that are typically used to smooth the d.c output of a rectifier - ANS -
Capacitors
- Inductors
- Resistors
The output circuit of an autotransformer MUST BE insulated for the highest input or output
voltage of the autotransformer. State ONE reason for this requirement - ANS An auto
transformer can fail in such a way so the primary voltage appears across the secondary
An isolator for 230V electrical equipment has been replaced. During the work the phase (active)
and neutral were accidentally transposed at the supply side of the isolating switch.
, What potential danger would this transposition create? - ANS The internal circuitry of the
electrical equipment would be live when the isolating switch is in the OFF position.
What to the initials BJT mean when applied to semiconductors - ANS A bi-polar junction
transistor
State the function of a transducer - ANS A device that changes energy from one form to
another
State TWO requirements for good illumination - ANS Any TWO of:
● Provides clear vision without eye strain
● Sufficient light intensity
● Minimum glare
● Uniform light intensity throughout the illuminated area
● Suitable colour rendering
XC - ANS Capacitive Reactance (ohms)
Explain why REWIREABLE FUSES are classed COARSE EXCESS CURRENT protection -
ANS There is no certainty that the fuse will operate within 4 hours at 1.5x it's rated current
Explain why gG type HRC fuses and MCBs are classed as close current protection - ANS The
HRC fuse or MCB will operate with certainty within 4 hours at 1.5x its rated current
The total time taken for a HRC fuse to operate is defined as the total operating (or clearance)
time. The total clearance time comprises the pre-arcing time and the arcing time.
1. Define the term pre-arcing time
2. Define the term arcing time - ANS 1. The pre-arcing time is the time taken for a fault current
large enough to operate the fuse. Or the time between the fuse elements beginning to melt and
the initiation of the arc
2. The arcing time is the time between the initiation of the arc and the extinguishing of the arc
Describe how correct discrimination is achieved between protective devices in an electrical
installation - ANS Only the protective devices closest to the fault operates
A MEN, low voltage electrical installation operates at standard low voltage
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller ALICE12. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for £8.93. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
75057 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy revision notes and other study material for 14 years now