100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
PW1100G Power Plant Chapter 70 Questions and Answers £10.89
Add to cart

Exam (elaborations)

PW1100G Power Plant Chapter 70 Questions and Answers

 5 views  0 purchase
  • Module
  • IFPC
  • Institution
  • IFPC

PW1100G Power Plant Chapter 70 Questions and Answers The Pratt and Whitney PW1100G is an? Axial flow, dual-rotor, geared fan, variable stator powerplant with an ultra high bypass ratio of 12:1 The Data Storage Unit provides? Where is it installed? -Engine parameters, thus allowing the pos...

[Show more]

Preview 2 out of 10  pages

  • December 17, 2024
  • 10
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • IFPC
  • IFPC
avatar-seller
PW1100G Power Plant Chapter 70
Questions and Answers
The Pratt and Whitney PW1100G is an? - answer Axial flow, dual-rotor, geared fan,
variable stator powerplant with an ultra high bypass ratio of 12:1

The Data Storage Unit provides? Where is it installed? - answer -Engine parameters,
thus allowing the possibility of changing the thrust rating
-It is installed on the EEC channel A side and is connected to the engine case bracket
via a lanyard.

The engine mounts are located? - answer -The Forward Engine Mount is located on
the Compressor Intermediate Case (CIC).
-The rear mount is located on the Turbine Exhaust Case (TEC)

The Fan Drive Gear System does what? - answer It allows the Fan and Booster
compressor to operate at different speeds, thus increasing engine efficiency

The Low Pressure Compressor is made up of how many stages? - answer 3 Stages
for the Low Pressure Compressor

8 Stages for the High Pressure Compressor
2 Stages for the High Pressure Turbine
3 Stages for the Low Pressure Compressor

What are the 3 types of bearing used and where are they located? - answer Taper
bearing at positions 1 and 1.5
Ball bearing at stages 2 and 3
Roller bearing at stages 4, 5 and 6

Where is the accessory gearbox located? - answer Under the core engine and is
driven by the HPC rotor via the angle gearbox

The Propulsion Control System (PCS) consists of? - answer -The FADEC system
consists of an Electronic Engine Control (EEC) and a Prognostic Health Monitoring Unit
(PHMU)
-The Engine Interface Unit (EIU)

The Prognostic Health Monitoring Unit (PHMU) interfaces with the EEC and monitors
for? - answer -Engine Vibrations
-Oil Debris

, The Fan Cowl Latches are monitored by? - answer Proximity Switches which send
their position signals to the EIU

During a Thrust Reverser deploy command, the SEC computers do what? - answer
Authorize unlocking of the Tertiary Locks on the Translating Sleeves

When inhibiting the Thrust Reversers, the Hydraulic Control Unit can be inhibited via? -
answer A remote level, accessible via the Oil servicing panel. It is located above the
oil tank on the LH side of the engine.

The Oil System consists of? - answer An Oil tank, oil pumps located within the
Lubrication and Scavenge Oil Pump Unit (LSOP), Oil Control Module (OCM) , filters and
heat exchangers

What Oil system parameters are monitored? - answer

The EEC controls the Starter Air Valve (SAV) to? - answer Supply air to the Starter
for initial N2 rotation

The FADEC is powered? - answer -When the ENG GND PWR P/BSw is ON
-When the Master levers are On
-When the Eng Mode Sw is set to Start or Crank

When opening Fan and Reverser Cowls you must? - answer Makes sure the Slats
are retracted and deactivated. If they are deployed they will strike the cowls

The FADEC Permanent Magnet Alternator is located on? - answer The forward face
of the main gearbox

The Ignition Exciter Box is located? - answer On the Rh side of the engine fan case
at the 5 o'clock position

Where is the Air Starter located? - answer

The primary components of the fuel system are located? - answer On the RH side of
the engine core

The Integrated Fuel Pump and Control is located? - answer On the right side of the
main gearbox at the 3 o'clock position. It is attached with bolts to the fuel manifold

Where is the Lubrication and Scavenge Oil Pump is located? - answer On the rear of
the main gearbox at the 6 o'clock position

The main oil system components are located? - answer On the LH side of the
Engine

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller Pogba119. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for £10.89. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

50990 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy revision notes and other study material for 15 years now

Start selling
£10.89
  • (0)
Add to cart
Added