package deal for NCTI EXAM (2023)already passed

NCTI Installer Tech/November question with complete solution 2023Why do only the outer electrons leave their orbit shells? - correct answer Only outer electrons leave their orbit shells because electrons farthest from the nucleus are more easily freed from their orbits due to a weaker electrostatic ...

Ncti 6 question with complete solution 2023 updated to passTh public switched telephone network (PSTN) uses pulse code modulation (PCM) to perform which function - correct answer Convert an analog signal (human voice) into digital signals so that man calls can travel over the same wire In plain o...

NCTI question and answers graded A+ 2023 already passed Which of the following devices were used to capture TV signals in the early days of television? A) Microwave Antenna. B) Antenna placed on the roof. C) Satellite Dish. D) Dowser Rod. - correct answer B) Antenna placed on the roof. Wh...

NCTI question with complete solution graded A+ 2023 passedQuestion - correct answer Answer What was the primary driver for development of IPv6? - correct answer To address the issue of IPv4 address exhaustion. When comparing IPv4 to IPv6, which of the following statements is true - correct ans...

NCTI Field Tech 2 to 3 correctly answered to pass 2023What is one reason why broadband cable operators install fiber optic cables in stages instead of changing the infrastructure all at once - correct answer Changing the infrastructure all at once would cause too many service disruptions What is ...

NCTI Installer Tech Multiple Choice Part 1 correctly answered rated A+ 2023 20 milliamperes is the same as _________ amperes. A 2 B 0.2 C 0.02 D 0.002 - correct answer C The orbital shell that has a maximum capacity of 18 valence electrons is the ________ shell. A First B Second C Third ...

NCTI Tech I to Tech II question with 100% correct answers 2023 Determining whether the cause of a problem is to one side or the other of a specific device describes what type of troubleshooting method? - correct answer The divide-and-conquer method of troubleshooting determines whether a problem i...

NCTI ROC II BOOK II FINAL Test 1 question with correct answers rated A+ 2023 When pressure testing a drop system to check for leakage, What must be done before applying the test signal? - correct answer The technician must isolate the drop system from the hybrid fiber/coax (HFC) network by disconne...

NCTI Service Technician: Think About it correctly answered to pass 2023What are three principle characteristics that define an AC waveform? - correct answer The three principle characteristics that define an AC waveform are: (1) frequency; (2) wavelength; and (3) amplitude. What is one of the bas...

NCTI - 2023 part II question with complete solution rated A+What major sources of television programming are available to broadband cable operators? - correct answer Over-the-air; terrestrial microwave; direct cable feed; satellites; and local origination programming. What are the three main elem...

Lesson II NCTI STUDY GUIDE question and answers rated A+ 2023 Through what equipment does a signal pass in the downstream path in the tree-and-branch architecture? - correct answer through trunk coax and amplifiers. Line splitters and directional couplers route some of the signal onto additional tr...

NCTI jones correctly answered 2023 updated to passif a customer already has television service and is adding high speed data service, what should be checked on the digital television channels? - correct answer intermittent operation, which is a symptom of noise interference in the downstream Inst...

NCTI MT2 - MT3 question and answers rated A+ 2023 In what applications is a splice closure used? - correct answer Splice closures are used to protect optical fibers and splices against a full range of environmental changes in aerial installations or below ground in vaults. When preparing a fiber...

Field Tech II - III Conventional – NCTI correctly answered graded A+ 2023 passedWhat is one reason why broadband cable operators install fiber-optic cable in stages instead of changing the infrastructure all at once? - correct answer Changing the infrastructure all at once would cause too many ser...