Case uitwerking
Report PCR
Case of 6 pages for the course Practical Lab Skills For Animal Sciences at WUR (Compleet rapport)
[Meer zien]Voorbeeld 2 van de 6 pagina's
Voorbeeld 2 van de 6 pagina's
In winkelwagengesponsord bericht van onze partner
Voorbeeld van de inhoud
Materials & MethodsFor a more detailed protocol, consult the lab journal of week 2.
Starting material was made for all experiments; an Eppendorf tube was filled with 250 µl water and a
single colony was picked from a blood agar plate. This colony was used for all subsequent
experiments to ensure cells with the same genetics.
Determine bacterial species by specific medium
Two different plates were marked: one with brain heart infusion
medium (BHI) and one with Mannitol salt agar (MSA). Figure 1
illustrates how a clean streak was made from the bacterial suspension
(i.e. starting material), a new sterile loop was used for each plate. Both
plates were incubated at 37°C.
Figure 1: Clean streak.
Determine bacterial species by specific PCR
A PCR pre-mastermix had been prepared that contained 5 μl Taq buffer (with loading dye), 0.25 μl
Taq polymerase, 0.5 μl deoxynucleotide triphosphates (dNTPs; 10mM) and 12.25 μl water. For the
mastermix, 8 μl primer mix was added to 72 μl pre-master mix. Table 1 shows characteristics of the
primers that were chosen with Primer3 software (actual primers were already chosen by supervisor
and had different characteristics). These primers were optimal in terms of the difference in melting
temperature, hairpins, self-dimer and hetero-dimer. The GC content of both was between 45-50%
and Gibbs free energy was close to zero for the reverse primer. Although the reverse primer had
three hairpins, all of them had melting temperatures below the ones the sample will endure during
PCR cycles.
Table 1: Primer characteristics
Forward primer Reverse primer
Length (bp) 20 20
Sequence 5’-3’ TGA GAC CGC AAG GTC TCT TT TGT GAC AAT CGC TTG CTT CT
Melting temperature (=Tm) 56.2 oC 54.9 oC
Hairpin structures 1: Tm = 68.8 oC, ΔG = -7.36 1: Tm = 30.1 oC, ΔG = -0.43
2: Tm = 23.3 oC, ΔG = 0.14
3: Tm = 20 oC, ΔG = 0.42
Free energy difference of self- -1.6 kcal/mole -1.47 kcal/mole
dimer (=ΔG)
Free energy difference of -1.57 kcal/mole
hetero-dimer (=ΔG)
, Table 2 demonstrates the pipetting scheme of
PCR samples. All samples were left on ice until
transferred to the PCR machine and cycled
according to figure 2.
Figure 2: PCR cycling program
Table 2 Pipetting scheme of PCR samples. Including positive control (+) and negative control (-)
Sample 1 (bacterial suspension) 2 (+) 3 (-)
Content 5 μl bacterial suspension 5 μl S. aureus DNA 5 μl non template
control (NTC)
PCR mastermix 20 μl 20 μl 20 μl
After PCR, 3.5 μl SYBR dye was added to all samples. A prepared agarose gel (1.5%) was put in the
electrophoresis device with Tris-acetate-EDTA (TAE) buffer. 15 μl of all three samples was loaded
onto the gel next to 7 μl molecular ladder. The gel could then be run at 80V for 30 minutes and
subsequently placed in a transilluminator.
Finally, a BLAST (Basic Local Alignment Search Tool) was done with the sequence of the chosen
primers and the sequence obtained by PCR.
Correlation of CFU & OD
First, 10 ml of BHI medium was added to a Greiner tube together with remaining bacterial culture
suspension (i.e. starting material). A negative control with only BHI medium was also used and the
tubes were put in a shaking incubator at 37°C (150 rpm) overnight.
First, a cuvette was filled with 1 ml BHI medium to blank the spectrophotometer. The OD 600 could
then be determined with 1 ml of overnight culture. The sample was diluted two times because 0.1 >
OD600 > 1. Lastly, the sample was diluted 1.81 times to get an OD 600 of 0.6.
The remaining sample was then used as
‘’undiluted’’ sample in a dilution series
illustrated by figure 3. The dilutions were
prepared in Eppendorf tubes before pipetting
100 μl of sample into the middle of five petri
dishes (10-4, 10-5, 10-6, 10-7, 10-8). The samples
were spread with a broad spreader and
incubated upside down overnight at 37°C.
The number of colonies could now be counted
on plates with 0-200 colonies to determine the Figure 3: Dilution series
colony forming units (CFU).
Determine MIC
Voordelen van het kopen van samenvattingen bij Stuvia op een rij:
Verzekerd van kwaliteit door reviews
Stuvia-klanten hebben meer dan 700.000 samenvattingen beoordeeld. Zo weet je zeker dat je de beste documenten koopt!
Snel en makkelijk kopen
Je betaalt supersnel en eenmalig met iDeal, creditcard of Stuvia-tegoed voor de samenvatting. Zonder lidmaatschap.
Focus op de essentie
Samenvattingen worden geschreven voor en door anderen. Daarom zijn de samenvattingen altijd betrouwbaar en actueel. Zo kom je snel tot de kern!
Veelgestelde vragen
Wat krijg ik als ik dit document koop?
Je krijgt een PDF, die direct beschikbaar is na je aankoop. Het gekochte document is altijd, overal en oneindig toegankelijk via je profiel.
Tevredenheidsgarantie: hoe werkt dat?
Onze tevredenheidsgarantie zorgt ervoor dat je altijd een studiedocument vindt dat goed bij je past. Je vult een formulier in en onze klantenservice regelt de rest.
Van wie koop ik deze samenvatting?
Stuvia is een marktplaats, je koop dit document dus niet van ons, maar van verkoper michouweimar. Stuvia faciliteert de betaling aan de verkoper.
Zit ik meteen vast aan een abonnement?
Nee, je koopt alleen deze samenvatting voor €2,99. Je zit daarna nergens aan vast.
Is Stuvia te vertrouwen?
4,6 sterren op Google & Trustpilot (+1000 reviews)
Afgelopen 30 dagen zijn er 53068 samenvattingen verkocht
Opgericht in 2010, al 14 jaar dé plek om samenvattingen te kopen