o Place the steps for part two of the pressure control test in the correct order: - 1. Set the fire pump so
that it is discharging at a net pump discharge pressure of 150 psi.
2. Reduce the pumping engine throttle until the net pump discharge pressure drops to 90 psi
3. Set the pressure control device to maintain the discharge pressure at 90 psi
4. Close the flowing valves one at a time.
5. The pump discharge pressure should rise no more than 30 psi when all valves are closed.
Two items that should be included on daily MWS records: - 1. Tire Conditions
2. Coolant levels
What re two daily inspection two perfom on a MWS equipped with a fire pump? - 1. Operate the pump
drive control
2. Confirm that the foam tank level is full.
Testing the discharge pressure gauge begins by: - Disconnecting all preconnected hose lines and screwing
all caps onto their discharges.
What is total stopping distance? - The sum of the driver/operator reaction distance and the MWS'
braking distance.
Three things you should do when turning an MWS 180 degrees? - 1. make sure you can see your spotter
2. Be aware of any obstructions in your line of travel
3. use the side view mirrors equipped on the MWS
, When performing the serpentine exercise, you should what? - Should only travel on one direction,
without striking the obstruction.
Two facts about looping mains in a distribution grid? - 1. They create a constant flow and less sediment
forms in the pipes.
2. They ensure that water flows from two directions into hydrants.
When a fire scene is located down a narrow lane, it is BEST to locate the dump site: - At the intersection
where the lane meets a thoroughfare.
What is the advantage of using an MWS with a Jet-assisted dump is that: - The in-line discharge creates a
Venturi effect increasing the water flow through the large tank discharge.
The fill site for a water shuttle operation may be shut down when: - all MWS have been refilled.
When operating a water shuttle operation involving a fill site pumper with 2 1/2" fill lines, what is the
recommended total number of make and break personnel that should be involved? - 2
When it becomes necessary for the dump site pumper to operate off its tank because the portable tanks
are empty then: - The attack pumper should be notifies that water loss is imminent.
During an MWS inspection, the lowest acceptable fuel gauge reading is: - at least 3/4 full
When conducting a service test using a static water source, you must have how many feet of HSH for
drafting? - 20 feet
During the pre-service hydrostatic test, each pump is hydrostatically tested at a minimum of: - 500 psi
over the pump's designed maximum operating pressure for ten minutes.
Two items that should be included on daily MWS records: - 1. Tire condition
2. Coolant levels
Voordelen van het kopen van samenvattingen bij Stuvia op een rij:
Verzekerd van kwaliteit door reviews
Stuvia-klanten hebben meer dan 700.000 samenvattingen beoordeeld. Zo weet je zeker dat je de beste documenten koopt!
Snel en makkelijk kopen
Je betaalt supersnel en eenmalig met iDeal, creditcard of Stuvia-tegoed voor de samenvatting. Zonder lidmaatschap.
Focus op de essentie
Samenvattingen worden geschreven voor en door anderen. Daarom zijn de samenvattingen altijd betrouwbaar en actueel. Zo kom je snel tot de kern!
Veelgestelde vragen
Wat krijg ik als ik dit document koop?
Je krijgt een PDF, die direct beschikbaar is na je aankoop. Het gekochte document is altijd, overal en oneindig toegankelijk via je profiel.
Tevredenheidsgarantie: hoe werkt dat?
Onze tevredenheidsgarantie zorgt ervoor dat je altijd een studiedocument vindt dat goed bij je past. Je vult een formulier in en onze klantenservice regelt de rest.
Van wie koop ik deze samenvatting?
Stuvia is een marktplaats, je koop dit document dus niet van ons, maar van verkoper learnsphere. Stuvia faciliteert de betaling aan de verkoper.
Zit ik meteen vast aan een abonnement?
Nee, je koopt alleen deze samenvatting voor €7,16. Je zit daarna nergens aan vast.