Unit A11 tsbc (2025 )Latest Questions With Passed Solutions!!
1 keer bekeken 0 keer verkocht
Vak
Unit A11 tsbc
Instelling
Unit A11 Tsbc
A pressure gauge on an ASME section IV steam boiler:
Select one:
a. Graduated to a maximum setting or double the MAWP
b. Graduated to no less than 30 psi (200 kPa), nor more than 60 psi (414 kPa)
c. Graduated to a maximum setting of double the PRV setting
d. Graduated to between 1.5 and 2 time...
Unit A11 tsbc
A pressure gauge on an ASME section IV steam boiler:
Select one:
a. Graduated to a maximum setting or double the MAWP
b. Graduated to no less than 30 psi (200 kPa), nor more than 60 psi (414 kPa)
c. Graduated to a maximum setting of double the PRV setting
d. Graduated to between 1.5 and 2 times the PRV setting - ✔️✔️B
(4-051-2.1) The Haycock boiler was:
Select one:
a. A watertube design
b. A return tubular design
c. Used around 1720
d. Of welded construction - ✔️✔️C
(4-055-8.1) In a bottom-supported boiler, the steam drum is usually:
Select one:
a. Supported by an overhead girder arrangement
b. Supported by the water tubes
c. Supported by piers
d. Placed between the centre line of the unit - ✔️✔️B
(4-054-1.16) The electrode type boiler:
Select one:
a. Requires a steady load
b. Must operate at very constant pressure
c. Utilizes bundles of electric elements
d. Requires water that conducts electricity - ✔️✔️D
R4A11-04-02-01 ) The operating voltage for a jet-type electrode boiler may be as high
as _________ kilovolts:
Select one:
a. 30
b. 25
c. 5
d. 55 - ✔️✔️B
,(4-090-2.2) In a cast iron modular heating boiler, the operation of the burner of each
module is controlled by a _____ that starts or stops modules in sequence as load
demand increases or decreases.
Select one:
a. Temperature sensor
b. Step controller
c. Thermostat
d. Flow controller - ✔️✔️B
(4-051-1.4) A _____ is a water filled section, which surrounds the firebox in a
locomotive boiler.
Select one:
a. Crown sheet
b. Boiler drum
c. Steam dome
d. Water leg - ✔️✔️D
Class 1 water treatment, as per ASME section VI, is suitable for:
Select one:
a. Cast Iron boilers
b. Watertube Heating Boilers
c. Firetube Heating Boilers
d. Tubular heating boilers - ✔️✔️A
(4-054-1.6) The amount of current passed through the water of an electrode boiler
depends on the:
Select one:
a. Depth of the electrodes in the water
b. Control valve setting
c. Speed of the circulating pump
d. Voltage setting of the pressure control - ✔️✔️A
(4-090-1.2) In a vertical sectional boiler, the sections are placed:
Select one:
a. One above the other
b. Side by side
c. On the furnace
d. Above the draft hood - ✔️✔️B
(4-056-1.16) When an air heater is used in a boiler:
Select one:
a. The induced draft fan supplies combustion air to the air heater
b. It increases the efficiency of the boiler
c. The boiler usually has only a forced draft fan
d. A balanced draft system cannot be used - ✔️✔️B
, (4-061-1.3) A cyclone separator in a boiler steam drum:
Select one:
a. Removes moisture from steam, using centrifugal force
b. Causes impurities to be thrown from the boiler water
c. Is located at the superheater outlet
d. Discharges water into the scrubbers - ✔️✔️A
(4-052-1.3) An internally fired boiler:
Select one:
a. Is less efficient than an externally fired unit
b. Utilizes a high amount of refractory and/or firebrick
c. Has the furnace surrounded by water
d. Requires a setting - ✔️✔️C
(4-055-1.3) Firetube boilers have their tubes fixed into flat steel plates, known as:
Select one:
a. Shells
b. Drums
c. Headers
d. Tube sheets - ✔️✔️D
4-052-3.3) An advantage of a vertical tubeless firetube boiler is that it requires:
Select one:
a. Relatively small floor space
b. No fuel handling equipment
c. Less fuel for combustion
d. Very little water treatment - ✔️✔️A
Operational system checks (rounds) are required, with the results recorded on log-
sheets, as per the samples found in :
Select one:
a. ASME section I
b. ASME section VII
c. ASME section VI
d. ASME section IV - ✔️✔️C
(4-061-1.2) Chemicals are introduced into the boiler:
Select one:
a. In the mud drum
b. By the internal feedwater pipe
c. In the injection tank
d. By the dry pipes - ✔️✔️B
4-055-1.2) One or more steel plates rolled into a cylinder welded together with the ends
closed by rounded heads, is called a:
Voordelen van het kopen van samenvattingen bij Stuvia op een rij:
Verzekerd van kwaliteit door reviews
Stuvia-klanten hebben meer dan 700.000 samenvattingen beoordeeld. Zo weet je zeker dat je de beste documenten koopt!
Snel en makkelijk kopen
Je betaalt supersnel en eenmalig met iDeal, creditcard of Stuvia-tegoed voor de samenvatting. Zonder lidmaatschap.
Focus op de essentie
Samenvattingen worden geschreven voor en door anderen. Daarom zijn de samenvattingen altijd betrouwbaar en actueel. Zo kom je snel tot de kern!
Veelgestelde vragen
Wat krijg ik als ik dit document koop?
Je krijgt een PDF, die direct beschikbaar is na je aankoop. Het gekochte document is altijd, overal en oneindig toegankelijk via je profiel.
Tevredenheidsgarantie: hoe werkt dat?
Onze tevredenheidsgarantie zorgt ervoor dat je altijd een studiedocument vindt dat goed bij je past. Je vult een formulier in en onze klantenservice regelt de rest.
Van wie koop ik deze samenvatting?
Stuvia is een marktplaats, je koop dit document dus niet van ons, maar van verkoper PatrickKaylian. Stuvia faciliteert de betaling aan de verkoper.
Zit ik meteen vast aan een abonnement?
Nee, je koopt alleen deze samenvatting voor €7,84. Je zit daarna nergens aan vast.
