STSC Certification Exam || With 100% Verified Solutions

STSC Certification Exam || With 100% Verified Solutions STSC Certification Exam || With 100% Verified Solutions For construction, electrical power tools and cords must? - ANSWER - must make use of ground fault circuit interrupted or an assured equipment grounding conductor program. Requirements for an assured grounding conductor program - ANSWER - requires extensive work site controls, inspections and recordkeeping A typical extension cord grounding system has four components: - ANSWER - 1. A third wire cord, called a ground wire 2. A three-prong plug with a grounding prong on one end of cord 3. A three-wire, grounding-type receptacle at the other end of the cord 4. A properly grounded outlet A certified STS is expected to do the following - ANSWER - Seek methods to improve your knowledge and understanding of methods, techniques and practices for protection of workers. hazard control sequence - ANSWER - engineer out the hazard, guard the hazard, educate personnel which action is preferred when dealing with minor infractions of work or safety rules? - ANSWER - oral reprimand system safety analysis can be applied to which of the following? - ANSWER - the discipline if system safety can be applied to almost any system that has interacting components. the strongest motivator, according to the Contemporary Motivation Theory is? - ANSWER - recognition of achievement the best evaluation of tasks descriptor involving steps, hazards, and solutions is - ANSWER - job safety analysis (JSA) System Saftey Analysis - ANSWER - A broad term coveting all if the various system safety tools used in analysis of system risk A crew member deliberately violated a safety procedure. what should be done? - ANSWER - stop work, write formal disciplinary report, and explain reasoning to worker. Recordable occupational illness on OSHA 300 log are categorized as follows - ANSWER - injury, skin disorder, respiratory conditions, poisoning, hearing loss, all other illnesses Which of the following wpuld not be included under the provisions of ANSI Z16.2, the standardized method of recording accident falls?