NCTI MT1-MT2 Exam Questions With
Correct Answers 2023
According to SCTE- and NCTA- recommended trunk system map symbols, fiber-optic
cable is represented by - AnswerDouble arrows within a small circle on a solid line.
The forward path signal in a traditional tree-and-branch architecture - Answeroriginates
at the headend and is transmitted downstream through coaxial trunk cable and trunk
amplifier.
In a HFC network, - AnswerProcessing equipment in the headend converts the forward
RF signal to a light signal.
During aerial plant construction, - AnswerThe strand is tensioned so its sag profile
matches that of the overhead utility power lines.
With underground plant construction, - AnswerThe fiber-optic and coaxial cables are
often places underground with other utility lines to jointly share construction costs.
Standby power supplies - Answercontinue providing an output voltage even during a
utility power outage by using a back up power source.
Centralized power configurations - Answerprovide the advantage of increased reliability
through sharing of expensive backup generators and sophisticated monitoring
equipment among different power realms.
When transmitting broadband signals - AnswerIn a two way hybrid fiber/coax (HFC)
network, two or more individual optical fibers are required for each optical node location.
RF trunk amplifiers - AnswerHave attenuator pads, equalizers, and duplex filters that
control and route the RF signals.
Verifying plant reliability includes - AnswerFrequency response sweeping, which is
adjusting RF amplifier circuits to amplify all frequencies in the bandpass spectrum as
equally as possible
Which of the following is a requirement in the process for measuring leakage using a
dipole antenna, as required by the FCC? - AnswerThe antenna must be placed 3
meters from the system components and 3 meters from the ground.
Many cable companies require which type of leaks to be fixed? - AnswerAll types of
leaks must be fixed.
, According to the FCC, the leakage log should contain which of the following? -
AnswerThe probable cause of the leakage.
Which of the following FCC required information must a cable system keep on file for
two years? - AnswerAnnual CLI calculations, regular (quarterly) monitoring programs,
and a list of all channels used in the aeronautical bands.
If your leakage detector indicates there is a leak and displays a reading of 14 microvolts
per meter (uV/m) when you are 80 feet from a possible leak source, what is the
approximate calculated level of the leak from 10 feet? - Answer112 uV/m.
If a large signal leak is found in the aerial plant, what is a good first step in locating the
leak? - AnswerDrive around until an absolute peak is found.
Which of the following best describes demand maintenance procedures with regard to
signal leakage? - AnswerThe demand maintenance procedures can improve the CLI
measurement results by identifying and correcting the largest leaks first.
When troubleshooting signal leakage in the drop system, what is indicated if all signs of
signal leakage disappear when the ground block is disconnected and terminated on the
side connected to the customer premises? - AnswerThe backward route from the
ground block to the tap can be eliminated as a source of The backward route from the
ground block to the tap can be eliminated as source of leakage.
Which typical over-the-air signal sources can cause a false alarm with a signal leakage
detector? - AnswerTypical sources include aircraft communication signals and ham,
mobile, and government radio broadcasts.
When adjusting or selecting the elements of a dipole antenna for measuring signal
leakage, what is the approximate length of each element relative to the wavelength of
the signal being measured? - AnswerOne-quarter wavelength.
Which of the following problem(s) are caused by egress? - AnswerInterference with
aeronautieal navigation
and communication, amateur radio public service, and cellular communications.
What cumulative leakage index (CLI) meets Federal Communications Commission
(FCC) requirements? - Answer64 or less
What is the maximum allowable signal detectable in the airspace during a flyover? -
Answer10 uv/m.
CLI calculations do not include leakage below: - Answer50 uv/m.
Which of the following is a repair order specification when measuring leakage levels? -
AnswerThe location of the leak.
Voordelen van het kopen van samenvattingen bij Stuvia op een rij:
Verzekerd van kwaliteit door reviews
Stuvia-klanten hebben meer dan 700.000 samenvattingen beoordeeld. Zo weet je zeker dat je de beste documenten koopt!
Snel en makkelijk kopen
Je betaalt supersnel en eenmalig met iDeal, creditcard of Stuvia-tegoed voor de samenvatting. Zonder lidmaatschap.
Focus op de essentie
Samenvattingen worden geschreven voor en door anderen. Daarom zijn de samenvattingen altijd betrouwbaar en actueel. Zo kom je snel tot de kern!
Veelgestelde vragen
Wat krijg ik als ik dit document koop?
Je krijgt een PDF, die direct beschikbaar is na je aankoop. Het gekochte document is altijd, overal en oneindig toegankelijk via je profiel.
Tevredenheidsgarantie: hoe werkt dat?
Onze tevredenheidsgarantie zorgt ervoor dat je altijd een studiedocument vindt dat goed bij je past. Je vult een formulier in en onze klantenservice regelt de rest.
Van wie koop ik deze samenvatting?
Stuvia is een marktplaats, je koop dit document dus niet van ons, maar van verkoper SmartScores. Stuvia faciliteert de betaling aan de verkoper.
Zit ik meteen vast aan een abonnement?
Nee, je koopt alleen deze samenvatting voor €10,06. Je zit daarna nergens aan vast.