NCTI
Op zoek naar een samenvatting op de NCTI? Op Stuvia vind je meer dan 428 samenvattingen, aantekeningen en andere studiedocumenten voor alle vakken op de NCTI.
-
408
- 0
-
39
Vakken op de NCTI
Er zijn samenvattingen beschikbaar voor deze vakken op de NCTI
Studies op de NCTI
Er zijn samenvattingen beschikbaar voor de volgende opleidingen op NCTI
-
NCTI 408
Nieuwste samenvattingen NCTI
NCTI Questions and Answers Graded A 
Question Answer 
What was the primary driver for development of IPv6? To address the issue of IPv4 address 
exhaustion. 
When comparing IPv4 to IPv6, which of the following statements is true IPv4 uses a 32-bit 
address scheme, while IPv6 uses a 128-bit address scheme. 
In IPv6-enabled networks, static addressing is no longer allowed. FALSE 
Without IPv4's network address translation (NAT), IPv6 offers simpler packet construction and 
better support for peer...
NCTI 2-3 Questions and Answers 100% 
Pass 
What is the difference between the FTTN and FTTC topologies? An FTTC is allowed a 
smaller number of RF amplifiers between the optical fiber and the customer premises. 
What are the three categories of the fiber-optic cable used to identify the location of the fiber in 
the network? Truck, branch, and drop 
Which type of fiber topology used in a PON places the PON splitters at the headend while 
providing one designated fiber for every customer premise?...
NCTI Questions and Answers with 
Verified Solutions 
Which of the following devices were used to capture TV signals in the early days of television? 
A) Microwave Antenna. 
B) Antenna placed on the roof. 
C) Satellite Dish. 
D) Dowser Rod. B) Antenna placed on the roof. 
Why did cable companies implement microwave technology? 
A) Because the equipment was inexpensive. 
B) Largely because the microwave signal was not amplified to reach the cable system. 
C) To obtain a better signal quality than ...
NCTI WIFI (2022/2023) Rated A+ 
Notes 
Single input, single output (SISO) - Most systems have one radio and one antenna, and some 
systems have one radio and two antennas. 
Multiple input, multiple output (MIMO) - These systems use multiple radio chains in a single 
wireless chipset. 
Multi-user MIMO (MU-MIMO) - These systems use each radio chain on an access point to 
transmit to a unique client.Correct answer: 
Wired Equivalent Protection (WEP) - This type of security setup should never be use...
NCTI Consumer Digital Electronics 
Questions and Answers Already Passed 
What is the name of the group that established the initial technical standards for the television 
industry, ensuring a single system would deliver consistent service across the nation? The 
National Television System Committee (NTSC). 
What signal modulation technique do cable operators use to transport digital television signals 
through the cable network? Quadrature amplitude modulation (QAM). 
What is the major change i...
NCTI TECH 4 TO 5 CH. TEST STUDY 
GUIDE (2022/2023) ALREADY PASSED 
What term describes the number of wave crests that pass a fixed point during a particular period 
of time? Frequency 
In data networking, this term is defined as "Signals may flow in either direction, but not 
simultaneously". Half Duplex 
Two CPUs have the same size data bus. Which one will process data faster? The one with a 
higher clock speed 
This unique ID number is coordinated by the Institute of Electrical and Electroni...
NCTI RSC II CABLE NETWORK 
OVERVIEW: Understanding the Feeder 
System Questions and Answers with 
Verified Solutions 
What is one of the differences between tree-and-branch and hybrid fiber/coax (HFC) DESIGNS? 
Bandwidth in the downstream path. 
In the tree-and-branch design, the cable signal in the downstream path leaves the trunk at the 
bridge amplifier. There, It makes a transition to the feeder's domain, and the signal splits. What 
is the maximum number of output ports the split signal ca...
NCTI Installer Tech Exam Questions 
and Answers
NCTI Exam Questions With 100% Correct Answers
According to SCTE- and NCTA- recommended trunk system map symbols, fiber-optic cable is represented by - ️️Double arrows within a small circle on a solid line. 
 
The forward path signal in a traditional tree-and-branch architecture - ️️originates at the headend and is transmitted downstream through coaxial trunk cable and trunk amplifier. 
 
In a HFC network, - ️️Processing equipment in the headend converts the forward RF signal to a light signal. 
 
During aerial plant construction...